Uplogix 3200 Hard Drive Removal

Updated March 9, 2021. Written for LMS Version 6.2.

For certain secure locations, it may be necessary to remove the Uplogix 3200's hard drive before sending the Local Manager back as part of an RMA. This article describes how to remove the hard drive from the chassis. The drive can then be destroyed; it does not need to be returned to Uplogix.

1. Remove Screws From Cover

Remove the two cover screws from the back of the 3200. Be careful not to strip the screws when removing and replacing. Serial Pin Out Figure 1: Back of u3200. Cover screws circled in red.

2. Remove Cover

Slide the cover back to disengage from the chassis. Lift the cover from the chassis. Serial Pin Out Figure 2: u3200 with chassis slid back.

3. Remove Hard Drive Mounting Screws

The top of the hard drive has 7 screws, but only 3 attach the drive to the chassis. The mounting screws are circled in red in the picture below. Remove the screws and pull the hard disk from the chassis. The other 4 screws will be removed later in the process. Serial Pin Out Figure 3: Hard disk with mounting screws marked in red.

4. Disconnect the Cables

There are two cable harnesses connected to the back of the hard drive. Lift the drive out of the chassis and disconnect both the power and ribbon cables from the back. Note: Some models of 3200s have a chassis intrusion connector on the mounting bracket. This can be removed via the 2 screws seen in figure 4.
Serial Pin Out Figure 4: Disconnecting the cables from back of drive with chassis intrusion connector.

Serial Pin Out Figure 5: Disconnecting the cables from back of drive without chassis intrusion connector.

5. Close Chassis

Place the lid back on the chassis and slide into place. Do not reinsert the cover screws. They can be thrown away. Place the chassis in box to ship back to Uplogix.

6. Remove Mounting Bracket From Drive

Remove the last 4 screws from the top of the hard drive mounting assembly. Place the mounting bracket inside the box with the chassis (but not in the chassis).

Serial Pin Out Figure 6: Drive and mounting bracket assembly.

Not finding what you're looking for?

The Uplogix Technical Support team is standing by 24/7/365 to answer any questions you may have about the installation, configuration, and usage of our products. Give us a call at 888.663.6869 or email us at support@uplogix.com.

About Uplogix

Uplogix is the most evolved out-of-band solution on the market. Our intelligent console server monitors network devices and takes actions directly over the console port, like an onsite technician plugging in a laptop.

Want to find out how Uplogix can help manage your network? Drop us a note!

Learn more:

Solutions Products Resource Center About Us Schedule a demo

© 2022 Uplogix, Inc., All Rights Reserved.

Contact Uplogix Support
+1 (888) 663-6869
+1 (512) 857-7070
Sales Assistance
General Inquiries