Enable Serial Redirect

Enabling serial redirection on the Control Center will allow you to access the operating system's command line from the serial port. This is useful if the Control Center is being managed by a Lantronix appliance.

Log in as emsadmin and become root

[emsadmin@vUCC-Eval ~]$ sudo su -
[sudo] password for emsadmin:
[root@vUCC-Eval ~]#

Edit /etc/inittab

Add the following line to: /etc/inittab

co:2345:respawn:/sbin/agetty ttyS0 9600

Other Linux systems may require:

7:2345:respawn:/sbin/mingetty ttyS0

If there are any other lines in inittab that reference ttyS0, delete them.

Save the file and exit.

Refresh Init

Run the following command to reload inittab.

kill -1 1

Edit /etc/securetty so that root can log in

Add ttyS0 to /etc/securetty

[root@ems18 ~]# cat /etc/securetty
console
vc/1
vc/2
vc/3
...
tty10
tty11
ttyS0

Save the file and exit.

Edit the grub configuration file

Add the following to /boot/grub/grub.conf for each line that begins with kernel.

console=ttyS0,9600

Here is an example grub.conf

title Fedora Core (2.6.22.14-72.fc6PAE)
root (hd0,0)
kernel /vmlinuz-2.6.22.14-72.fc6PAE ro root=/dev/VolGroup00/LogVol00 rhgb quiet console=ttyS0,9600
initrd /initrd-2.6.22.14-72.fc6PAE.img

Enable console redirection in BIOS

Restart the Control Center with a keyboard/monitor attached and access the BIOS. Find the tab related to Console Redirection and enable it. Do not enable the feature that says "Redirect console AFTER boot." Post-boot communication will be handled by Linux with the settings above.

Complete

You should now be able to communicate with your Control Center via the serial port. Please contact Lantronix Support if the above steps do not work.