You are here: Documentation Library > Command Reference > System Resource > show system protocols

show system protocols

Displays the Uplogix Local Manager’s inbound connectivity configuration, including Telnet, SSH, IP address filtering, and DHCP base address.

Command availability

CLI resource: system

Uplogix system: All

LMS offerings: All


show system protocols [-s]

-s – displays filter statistics


Protocol changes take effect after restart. This command shows the current settings; however, if the system has not been restarted, the settings may not be in effect.

[admin@UplogixLM]# show system protocols
Telnet: disabled
Server DHCP base address: 169.254.100
sshPort: 22
Preferred Encryption Cipher:3des-cbc
Allow: aes128-cbc
Allow: aes128-ctr
Allow: aes192-cbc
Allow: aes192-ctr
Allow: aes256-cbc
Allow: aes256-ctr
Allow: blowfish-cbc
Allow: cast128-cbc
Allow: twofish128-cbc
Allow: twofish192-cbc
Allow: twofish256-cbc
Preferred HMAC:hmac-sha1
Allow: hmac-md5
Preferred Compression:none
Allow: zlib
Preferred Key Exchange Algorithm:diffie-hellman-group1-sha1
Allow: diffie-hellman-group14-sha1

In the Uplogix web interface

Inventory > group page > Network > Protocols - specific to this inventory group

Inventory > Local Manager page > Network > Protocols - specific to this system


3.4 - This command was introduced to replace show envoy protocols. DHCP information was added.

3.5 – Command output was expanded to show configurable ssh options.

Related commands

  • config system protocols dhcp
  • config system protocols filter
  • config system protocols ssh
  • config system protocols telnet