Server settings can be accessed from the Administration tab on the main navigation bar. It is the default view presented when the Administration link is clicked.
Once settings have been changed, click Save in the upper right or lower right to save the new settings.
This section provides the following information:
Specify the text to display in the Control Center login screen. Line breaks entered in this text box are ignored.
Use only printing characters in the banner and other text fields. Spaces are considered printing characters.
By default, Control Center sessions time out after 30 minutes of inactivity. If this does not meet your organization's needs, change the value for Session timeout. You can set the timeout to any integer value from 5 to 1440 minutes (24 hours).
Once finished making changes, click Save.
The session timeout for Local Managers is set separately.
If your session times out, you will be logged out but any operation in progress will not be affected. When you log in again, you are returned to the same page.
Setting the time zone does not change the system time of the Control Center. This setting is only used for display purposes. The Lantronix Control Center should always be set to UTC time.
Select Use DST to adjust Daylight Saving time in reporting.
See Configuring Mail Settings.
See Configuring Reverse SSH Tunnels.
The Control Center can be configured to send SNMP traps to an SNMP manager. Traps collected from Local Managers will be sourced with the Local Manager's IP address.
SNMP MIB definitions are available under /home/emsadmin/ on the Control Center.
[emsadmin@LantronixControlCenter ~]$ less uplogix-mib.txt
--
-- Lantronix Enterprise Specific MIB: Chassis MIB
--
-- Copyright (c) 2016 Lantronix, Inc.
-- All rights reserved.
--
-- The contents of this document are subject to change without notice.
--
-- Generated: 2016-01-28T22:09:33-06:00
UPLOGIX-SMI DEFINITIONS ::= BEGIN
IMPORTS
NOTIFICATION-GROUP
FROM SNMPv2-CONF
OBJECT-TYPE, MODULE-IDENTITY,
OBJECT-IDENTITY, NOTIFICATION-TYPE, enterprises
FROM SNMPv2-SMI
DisplayString
FROM SNMPv2-TC;